In this paper, a series of Cu-Fe-Ti and Co-Fe-Ti oxide catalysts were prepared by sol gel method. Cu-Fe-Ti and Co-Fe-Ti oxide catalysts showed the moderate catalytic activity for selective catalytic reduction (SCR) of NO with NH3 at low temperature. The catalysts with the molar ratio as 4:1:10 (M:Fe:Ti) were selected as the representatives for comparison of reaction properties and H2O resistance, which were denoted as Cu-Fe/TiO2 and Co-Fe/TiO2 respectively. The characterization results manifested Co-FeiTiO(2) owned more adsorption capacity of the reactants and Cu-FeiTiO(2) had better redox ability. The in situ DRIFTS experiments indicated that adsorbed NH3 species and nitrate species both exhibited reaction activity for CoFe/TiO2, while nitric oxide was only be reduced by adsorbed NH3 species through Eley-Rideal mechanism for Cu-FeiTiO(2) at 150 degrees C. Co-Fe/TiO2 exhibited the better resistance to H2O and its temperature window shifted towards the higher temperature in presence of 10 vol% H2O, while the SCR activity of Cu-Fe/TiO2 was inhibited significantly in the whole temperature range investigated. The suppression of adsorption and activation for NH3 and NOx might be the reasons for the reversible inactivation, which was confirmed by the inhibitation of catalytic activities for separation NH3 and NO oxidation under the wet condition. We speculated that different thermal stability of adsorbed species and redox capacity of catalysts leaded to the different SCR behavior in absence and presence of H2O. (C) 2016 Elsevier Inc. All rights reserved.