Adsorption of Cr(VI) on MnO2 was investigated with respect to effect of pH, temperature, ionic strength, initial Cr(VI) concentration, co-presence of different anions (HCO3-, SO42-, H2PO4-, NO3- and Cl-) and of low molecular weight natural organic materials (LMWNOM) (acetate, oxalate and citrate). The process was rapid during the first 3-5 min, reaching equilibrium after one hour. Adsorption decreased with increasing pH, temperature and Cr(Vl) initial concentration, and increased with increasing ionic strength. Co-presence of phosphate, sulfate, bicarbonate, citrate and oxalate hindered Cr(VI) adsorption, whereas nitrate, chloride and acetate did not exert any notable influence. The overall order of Cr(VI) adsorption suppression due to co-presence of anions and LMWNOM was H2PO4 > HCO3- > SO42-, and oxalate > citrate, respectively. Highest experimental equilibrium sorption capacity (0.83 mg g(-1)) was obtained at 20 degrees C and pH 5.9, while lowest (0.18 mg g(-1)) was noticed in the co-presence of H2PO4-, at 20 degrees C and pH 6.9. Adsorption kinetics was successfully fitted by pseudo-second-order model. Mechanisms for both specific and non-specific adsorption are likely to be involved, while rate-controlling step involved both intra-particle and film diffusion processes. Cr(VI) was strongly bound to MnO2, which makes risks of its subsequent liberation into the environment to be low. (C) 2016 Elsevier B.V. All rights reserved.