Tidal heterolithic sandstone reservoirs are heterogeneous at the submeter scale because of the ubiquitous presence of intercalated sandstone and mudstone laminae. Core-plug permeability measurements fail to sample a representative volume of this heterogeneity. Here, we investigate the impact of mudstone drape distribution on the effective permeability of heterolithic, cross-bedded tidal sandstones using three-dimensional, surface based "minimodels" that capture the geometry of cross beds at an appropriate scale. The impact of seven geometric parameters has been determined: (1) mudstone fraction, (2) sandstone laminae thickness, (3) mudstone drape continuity, (4) toeset dip, (5) climb angle of foreset toeset surfaces, (6) proportion of foresets to toesets, and (7) trough or tabular geometry of the cross beds. We begin by identifying a representative elementary volume of I. m(3) (similar to 35 ft(3)), confirming that the model volume of 9 m(3) (similar to 318 ft(3)) yields representative permeability values. Effective permeability decreases as the mudstone fraction increases, and it is highly anisotropic: vertical permeability falls to approximately 0.5% of the sandstone permeability at a mudstone fraction of 25%, whereas the horizontal permeability falls to approximately 5% and approximately 50% of the sandstone value in the dip (across mudstone drapes) and strike (parallel to mudstone drapes) directions, respectively. Considerable spread exists around these values, because each parameter investigated can significantly impact effective permeability, with the impact depending upon the flow direction and mudstone fraction. The results yield improved estimates of effective permeability in heterolithic, cross-bedded sandstones, which can be used to populate reservoir-scale model grid blocks using estimates of mudstone fraction and geometrical parameters obtained from core and outcrop-analog data.