Poly(ether sulfone) 10 kDa ultrafiltration membranes were modified by photolysis using ultraviolet light and graft polymerization of hydrophilic monomers onto the membrane surface to create more hydrophilic and lower fouling membrane surfaces. The modified membrane surfaces were characterized by FTIR/ATR and captive bubble contact angle measurements to determine chemical and hydrophilicity changes during modification. The modified membranes were compared with an unmodified poly(ether sulfone) (control) membrane as well as a commercial regenerated cellulose and a low protein adsorbing poly(ether sulfone) membrane using a newly developed standardized filtration protocol with 1 wt% bovine serum albumin. The best performing modified membrane was with N-vinyl-2-pyrrolidinone and showed a 25% increase in hydrophilicity, a 49% decrease in bovine serum albumin fouling, and a 4% increase in bovine serum albumin retention compared to the unmodified poly(ether sulfone) membrane. While the regenerated cellulose membrane had the lowest fouling and the low protein adsorbing membrane had the highest flux of all tested membranes, the N-vinyl-2-pyrrolidinone-modified membranes had the best combination of low fouling and high flux.