The surface electrochemical properties of alumina based ceramic microfiltration membranes were studied by measuring electroosmotic rates and surface charge densities obtained from potentiometric titrations. The rate of electroosmosis, which determines the zeta-potential, was measured on the membrane itself, whereas the surface charge was titrated on a suspension obtained by crushing of the membrane. The zeta-potential was measured in the presence of salts including NaCl, CaCl2 and Na2SO4, for a wide range of pH values (4-9) at ionic strengths of 0.01 and 0.001 M. The pH value of the isoelectric point (iep) show a specific adsorption of SO42- and Ca2+ ions onto the membrane surface. The iep in NaCl solutions occurs at pH 4.7 +/- 0.1. The low iep is due to the large amount of silicium oxide in the membrane. The surface charge density is relatively high with respect to the low values of zeta-potentials. The point of zero charge pH(pzc) determined from surface charge and pH profiles occurs at pH 8.2 +/- 0.1 in NaCl solutions. The pH(pzc) value was also determined by two ’addition’ methods. Similar pH(pzc) values were obtained. The difference between the pH(pzc) and pH(iep) may be correlated to a loss of acidity that is due to using crushed-membrane powder to perform potentiometric measurements.