The structure and properties of polypropylene (IPP) and ethylene propylene copolymer (IEPR) blends filled with nanosilica have been investigated. The nanocomposites were prepared via direct melt mixing using high shear corotating twin screw extruder. The effects of the process as well as adding amaleated-Polyethylene MAPE compatibilizer were assessed by morphology studies, thermal analysis and mechanical testing. From SEM and TEM investigations, a separate dispersion of filler and rubber in the PP matrix prevails in the PP/EPR/SiO2 systems. Encapsulation of the filler particles into the elastomer takes place when MAPE is used, promoting filler/polymer interactions and resulting in a simultaneous improvement in stiffness and toughness. Interestingly, the results indicated that high-shear processing is an effective method to improve the dispersion of the EPR phase and fillers through the matrix. The dispersed phase droplet size was reduced with the increase of the shear rate by varying the screw rotation speed from 300 to 800 rpm, which induces a high shear stress exerted onthe materials. To sum up, what is expected from an efficient compatibilization-process association is the reduction of the dispersed elastomer domains characteristic size, their stabilization by creation of an interphase and thus, enhanced mechanical properties. (C) 2015 Society of Plastics Engineers