Processability of complex, low-grade nickel (Ni) laterite ores via heap leaching is very limited due to some intractable geotechnical and hydrological challenges such as poor heap porosity/permeability and structural stability. This work presents some investigations on laboratory batch drum agglomeration and continuous column leaching behaviour of saprolitic (SAP) and goethitic (G) Ni laterite ores as part of the quest for an effective ore pre-treatment process for enhanced heap leaching. As a focus, the effect of ore mineralogy/chemistry on the agglomeration and column leaching behaviour of-2 mm (crushed from -15 mm run-of-mine) G and SAP Ni laterite ores was examined. To produce similar to 5-40 mm agglomerates in <15 min, the SAP ore required a higher H2SO4 (30 wt.%) binder dosage compared with the G ore, although both ores displayed substantially similar, coalescence-controlled agglomeration mechanism. The resulting G agglomerates were more robust than the SAP ones based upon their compressive strength and acidic solution soak test measurements. However, over 100 days of continuous column leaching, the structural stability of the SAP agglomerate bed was slightly greater than that of G agglomerates, reflecting a lesser slump of the former. The pregnant leach solution analysis revealed greater Ni/Co extraction rates from the SAP than the G agglomerates. Whilst the total mass of acid consumed per ton dry ore processed was greater for the SAP ore, the total kg acid per kg Ni extracted was markedly lower. Incongruent leaching of gangue minerals' constituent elements (e.g., Fe, Mn, Mg, Al and Si) occurred and contributed significantly to the overall acid consumption. The findings show the relevance of agglomeration and column leaching tests for providing useful information for plant designing and optimization of Ni laterite heap leaching operations. (C) 2014 Elsevier Ltd. All rights reserved.