Manganese oxide supported on mesoporous silica SBA-15 catalyst (Mn-SBA-15) was tested with Mn contents in the range of 0.8-23 wt%. Samples were prepared by the controlled grafting process of atomic layer deposition (ALD). Other sample was prepared for comparisons by the wet impregnation method. These samples were characterized by the techniques of ICP, XRD, SEM, Raman, FT-IR spectroscopy, diffuse reflectance UV-Vis, TGA-DSC, and N-2 absorption-desorption surface area measurement. Results indicated that anchored manganese oxide particles have been successfully synthesized over the surface of SBA-15. These samples contained Red-Ox ion pairs of Mn2+ and Mn3+ highly dispersed on the mesoporous silica surface. The impregnated sample exhibited lower surface area and contained Red-Ox ion pairs of Mn3+ and Mn4+ more aggregated particles on the SBA-15 surface. Results determined Mn-SBA-15 as an efficient and selective catalyst for oxidation of benzyl alcohol with tert-butylhydroperoxide in liquid phase. In accordance with expectations, there was a negligible amount of leaching of immobilized manganese oxide from the support during the reaction, because of strong surface interaction between manganese oxide and hydroxyls groups. The influences of reaction temperature, reaction time, solvent, TBHP/benzyl alcohol molar ratio, amount of catalyst and reusability were investigated. Under optimized conditions (0.2 g catalyst, TBHP/benzyl alcohol molar ratio 1, solvent acetonitrile; T = 90 degrees C; reaction time 8 h), results achieved 70% conversion of benzyl alcohol and 100% selectivity to benzaldehyde. (C) 2015 Elsevier B.V. All rights reserved.