In this paper, poly(n-butyl acrylate)-g-poly(methyl methacrylate) multigraft copolymers were synthesized by macromonomer technique and miniemulsion copolymerization. The PMMA macromonomers were obtained by an activator generated by electron transfer atom transfer radical polymerization (AGET ATRP) in emulsion system and subsequent allylation. Then the copolymerization of different macromonomers with nBA was carried out in miniemulsion system, obtaining multigraft copolymers with high molecular weight. The latex particles and distribution of emulsion AGET ATRP and miniemulsion copolymerization were characterized using laser light scattering. The molecular weight and polydispersity indices of macromonomers and multigraft copolymers were analyzed by gel permeation chromatography, and the number-average molecular weight range is 187,600-554,800 g/mol for PnBA-g-PMMA copolymers. In addition, the structural characteristics of macromonomer and brush-like copolymers were determined by infrared spectra and H-1 nuclear magnetic resonance spectroscopy. The thermal performance of brush-like copolymers were characterized by differential scanning calorimetry and thermogravimetric analysis. Atomic force microscopy results showed that the degree of micro-phase separation was varying with increasing PMMA content in PnBA-g-PMMA. The dynamic rheometer analysis revealed that multigraft copolymer with PMMA content of 31.4% exhibited good elastomeric properties to function as a TPE. These multigraft copolymers show a promising low cost and environmental friendly thermoplastic elastomer. (C) 2015 Elsevier Inc. All rights reserved.