- Previous Article
- Next Article
- Table of Contents
International Journal of Hydrogen Energy, Vol.40, No.46, 16860-16866, 2015
Lifetime and degradation of high temperature PEM membrane electrode assemblies
This work will provide details on some of the high temperature polymer electrolyte membrane (HTPEM) membrane-electrode-assembly (MEA) performance targets most recently achieved by Danish Power Systems. These include (i) MEA performances of >0.67 V at 0.2 A cm(-2) using dry H-2/Air, (ii) MEA lifetime of 17.000 h at 0.24 A cm(-2) using dry H-2/Air with an average degradation rate of 9 mu V h(-1), and (iii) an integrated 5 kW stack/reformer system using methanol reformate as fuel. Post mortem SEM, TEM, micro-tomography and XRD showed membrane thinning and catalyst particle growth that is typical for PEM fuel cells. Platinum particles grew from an initial 2-3 rim to 6-8 nm at the cathode and 4-5 nm at the anode, while the membrane showed thinning from an undoped 40 mu m-18 gm in some areas after testing. Studies using reformate have also led to promising initial results, while the rate of degradation for an MEA supplied with wet H-2 (30 mol%)/Air for 2000 h was found to be very similar to the rate when supplied with dry H-2. In addition to reaching these performance benchmarks, a reduction in the standard deviation for MEA cell voltage at 0.2 A cm(-2) to <1% has been achieved through efforts aimed at improving the uniformity of the membrane and catalyst layer thicknesses. Copyright (C) 2015, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.