An experimental apparatus has been built that provides information on forces associated with slitting plastic films. The apparatus uses commercially available scissors as an analogue to the counter-rotating knife blades used in industry. Cutting forces were measured using sharp and worn blades at a range of slitting speeds from 0.05-2.5 m s(-1) Two important film-base materials were studied; the first was polyethylene terephthalate (PET) and the second, acetal butylate. The influences of speed and knife-edge radius were measured for each base material. For the PET-based film, the forces increased as the blade became dull and decreased with cutting speed. At low speeds, the force required to cut the acetal butylate fi Im was independent of speed, but a sharp decrease in force was observed at a speed that depended upon the blade sharpness. An empirical model for the slitting process has been developed that can estimate the forces measured.