We report on the effects of six dyes used in the detection of DNA on the process of DNA extraction, amplification, and detection of STR loci. While dyes can be used to detect the presence of DNA, their use is restricted if they adversely affect subsequent DNA typing processes. Diamond (TM) Nucleic Acid Dye, GelGreen (TM), GelRed (TM), RedSafe (TM), SYBR (R) Green I, and EvaGreen (TM) were evaluated in this study. The percentage of dye removed during the extraction process was determined to be: 70.3% for SYBR (R) Green I; 99.6% for RedSafe (TM); 99.4% for EvaGreen (TM); 52.7% for Diamond (TM) Dye; 50.6% for GelRed (TM), and; could not be determined for GelGreen (TM). It was then assumed that the amount of dye in the fluorescent quantification assay had no effect on the DNA signal. The presence of all six dyes was then reviewed for their effect on DNA extraction. The t-test showed no significant difference between the dyes and the control. These extracts were then STR profiled and all dyes and control produced full DNA profiles. STR loci in the presence of GelGreen (TM) at 1X concentration showed increased amplification products in comparison to the control samples. Full STR profiles were detected in the presence of EvaGreen (TM) (1X), although with reduced amplification products. RedSafe (TM) (1X), Diamond (TM) Dye (1X), and SYBR (R) Green I (1X) all exhibited varying degrees of locus drop-out with GelRed (TM) generating no loci at all. We provide recommendations for the best dye to visualize the presence of DNA profile as a biological stain and its subsequent amplification and detection.