Applied Surface Science, Vol.332, 494-499, 2015
Thickness dependent structural, optical and electrical properties of Ti-doped ZnO films prepared by atomic layer deposition
Highly conductive and transparent titanium-doped zinc oxide (TZO) films with thicknesses ranging from 24 to 284 nm were deposited using atomic layer deposition. The TZO films change preferred orientation from c-axis orientation to a-axis orientation with increasing film thickness. Growth modeling suggests this may stem from hexagonal bipyramid grain shapes, or less likely a co-existence of aligned grains along either a- or c- axis. The surface grain size increases with film thickness from 15 to 30 nm for 24 and 284 nm thick films, respectively. Both carrier concentration and mobility increase with thickness, which is attributed to increased grain size and crystallinity. The lowest resistivity of 2.0 x 10(-3) Omega cm was achieved for the largest film thickness. The transmittance and reflectance of the TZO films show thickness dependent properties in the IR region caused by changes in carrier concentration, increasing carrier absorption and changing the plasma frequency to higher energy wavelengths. (C) 2014 Elsevier B.V. All rights reserved.
Keywords:Atomic layer deposition;Transparent conductor;Growth simulations;Structural properties;Optical properties;Electrical properties