The losses in Cu(In, Ga)Se-2 (CIGS) solar cells due to photovoltaic (PV) cell parameters, namely the shunt resistance R-sh, series resistance R-s, diode ideality factor n, and reverse saturation current density J(0), were analyzed in this study. The PV cell parameters of the solar cells were analytically determined for various doping concentrations of Cu and In in CIGS films. The CIGS films were deposited using a low cost non-toxic solvent (deionized) by a non-vacuum process (spray pyrolysis technique). They were subsequently characterized using XRD, FE-SEM, I-V and UV-Vis techniques to correlate the structural, electrical, and optical properties of the films with solar cell performance. Maximum short circuit current density of 0.0218 A/cm(2) is achieved for Cu/Se and In/Se molar ratios of 0.131 and 0.318, respectively. However, the maximum obtained V-oc value is 0.431 V for Cu/Se and In/Se molar ratios of 0.105 and 0.191, respectively. The maximum achieved efficiency was similar to 4.38% for Cu/Se and In/Se molar ratios of 0.105 and 0.191, respectively. Analytically predicted values of R-sh, R-s, n, and J(0) were 116.82 Omega cm(2), 4.64 Omega cm(2), 1.8016, and 1.4952 x 10(-6) A/cm(2), respectively. (C) 2014 Elsevier Ltd. All rights reserved.