Alkali anion exchange membrane (AEM) based devices have the potential for electrochemical energy conversion using inexpensive catalysts and a variety of fuel types. Membrane stability and anion transport must be improved in AEMs before these devices can be fully realized. Mechanical failure of the membrane can contribute to failure of the device, thus membrane durability is critical to overall system design. Here, a study of the Mechanical properties of three well-established AEMs uses a modified extensional rheometer platform to simulate tensile testing using small membrane samples. Mechanical properties were tested at 30 and 60 degrees C under dry or water saturated gas conditions. Water in the membrane has a plasticizing effect, softening the membrane and reducing strength. PEEK membrane reinforcement limits swelling producing negligible softening and only a 9% decrease in strength from dry to hydrated conditions at 30 degrees C. Higher cation concentration increases water uptake resulting in significant softening, a 57% reduction in Young's modulus, and a 67% reduction in strength when hydrated at 30 degrees C. In a working electrochemical device, AEMs must maintain integrity over a range of temperatures and hydrations, making it critical to considering mechanical properties when designing new membranes. (C) The Author(s) 2014. Published by ECS. This is an open access article distributed under the terms of the Creative Commons Attribution 4.0 License (CC BY, http://creativecommons.org/licenses/by/4.0/), which permits unrestricted reuse of the work in any medium, provided the original work is properly cited. All rights reserved.