A low-cost and highly efficient biosorbent was prepared by loading Al/Fe oxides onto tea waste and was tested for the ability to remove fluoride from drinking water. Key factors, including adsorbent dosage, initial fluoride concentration, contact time and initial pH of the biosorbent, were investigated. It was found that the solution pH played an important role in the removal of fluoride. The biosorbent combinations Tea-Al or Tea-Al-Fe could reduce the fluoride concentration to below 1.5 mg/L in the drinking water, a level which meets the drinking water standard recommended by the World Health Organization (WHO). In addition, the residual concentrations of Al and Fe in the drinking water after Tea-Al-Fe treatment were below the standards set by WHO when treatment was conducted at pH values ranging from 5.0 to 10.0. The experimental data were analyzed using two-parameter theoretical models. The maximum fluoride adsorption capacities for the original tea, Tea-Fe, Tea-Al and Tea-Al-Fe biosorbents were 3.83, 10.47,13.79 and 18.52 mg/g, respectively. These findings demonstrate the suitability of a prepared biosorbent based on tea waste for the removal of fluoride from drinking water. (C) 2014 Elsevier B.V. All rights reserved.