Since it was developed by Joseph Aspdin, cement has been a common construction materials up to the present time. However, there are trace constituents in cement clinker. One of the trace constituents included in cement clinker, chromium, has become prominent and highly noticed lately as a social issue both inside and outside of this country because it affects the human body negatively. The aim of the present study was to investigate the concentration of water-soluble hexavalent chromium in cement clinker by using industrial by-products. For that reason, raw materials were prepared to add different SiO2 , Al2O3, and Fe2O3 sources. After the raw materials such as the limestone, the sand and the clay, iron ore was pulverized and mixed, and the raw meal was burnt at about 1450oC in a furnace with an oxidizing atmosphere. The part in the raw materials of the clinker was substituted with slag, sludge, etc. and this was used to manufacturing cement clinker. To investigate the watersoluble hexavalent chromium content in clinker, raw meal was prepared by changing the modulus, the type, and the content of clinker materials and tested concentrations of hexavalent chromium in the clinkers. To determine Cr+6 formation of the clinker, tests were done with raw meals adding chromium by using different industrial by-products. Consequently because the chromium was to be included in the raw materials of the clinker, production of Portland cement clinker was included with the chromium. Also, the chromium was converted into hexavalent chromium in the burning process.