Experiments with different organic liquids have been conducted to study the drop size dependence of the contact angles on a self-assembled monolayer (SAM) surface of 1-octadecanethiol (HS(CH2)(17)CH3) on gold. Low-rate dynamic advancing contact angles were measured for sessile drops in vapor-saturated air using Axisymmetric Drop Shape Analysis-Profile (ADSA-P). The experiments were performed using a minimum of eight separately prepared SAM surfaces for each liquid. Although a degree of scatter in the measured contact angles existed, the general trend observed for each run was that the contact angles decreased as the radius of the three-phase line for the sessile drop increased from approximately 1 to 5 mm. To obtain a better view of the overall trend, the contact angles from all of the individual runs for each liquid were averaged at corresponding radii. Subsequently, the averaged results from these experiments were interpreted using the modified Young equation. It was found that the drop size dependence of contact angles was due to a positive line tension. The line tension values are of the order of 1 mu J/m with a trend toward larger values for higher liquid surface tensions.