In this study we present a direct comparison between residual strain measurements carried out on the same inertia friction weld using ENGIN-X at ISIS, UK and the new strain scanner SALSA at ILL, France. ENGIN-X is a time of flight (TOF) instrument, which receives neutrons from a neutron spallation source, while the SALSA Strain-Imager, a high resolution diffractometer, is based at a research reactor source with a continuous neutron flux and is operated with a constant wavelength. The purpose of this study was to demonstrate a confidence in cross-comparing future strain measurements to be performed at ENGIN-X and SALSA. Measurements were carried out on medium size inertia friction welded nickel superalloy test-piece, which show no significant crystallographic texture across the weld line. The results demonstrate that, even though residual stresses determined on SALSA only rely on a single peak analysis (in this case the (111) reflection), the results show excellent agreement with the measurements carried out on ENGIN-X, where strain is determined from multi-peak Rietveld analysis.