Deformation microstructures were studied in a two-phase (about 60% ferrite and 40% austenite) Fe - 27%Cr - 9%Ni stainless steel. Severe plastic working was carried out by rolling from 21.3x21.3 mm(2) to 7.8x7.8 mm(2) square bar followed by swaging from O7.0 to 0.6 mm rod at an ambient temperature, providing a total strain of 6.9. After a rapid increase in the hardness at an early deformation, the rate of the strain hardening gradually decreased to almost zero at large strains above 4. In other words, the hardness approached a saturation level, leading to an apparent steady-state deformation behaviour during cold working. The severe deformation resulted in the evolution of highly elongated (sub)grains aligned along the rolling/swaging axis with the final transverse (sub)grain size of about 0.1 mu m and the fraction of high-angle (sub)boundaries above 60%. However, the kinetics of microstructure evolution in the two phases was different. In the ferrite phase, the transverse size of deformation (sub)grains gradually decreased during the processing and approached 0.1 mu m at strains of about 6.0, while the transverse size of the austenite (sub)grains rapidly reduced to its final value of 0.1 mu m after a relatively low strain about 1.0.