The cationic and anionic amphiphilic diblock copolymers with a critical chain length and block ratio do not adsorb at the air/water interface but form micelles in solution, which is a phenomenon called "non-surface activity". This is primarily due to the high charge density of the block copolymer, which creates a strong image charge effect at the air/water interface preventing adsorption. Very stable micelle formation in bulk solution could also play an important role in the non-surface activity. To further confirm these unique properties, we studied the adsorption and micellization behavior of cationic amphiphilic diblock copolymers of poly(n-butyl acrylate)-b-poly(3-(methacryloyloxy)ethyl)trimethylammonium chloride) (PBA-b-PDMC) with different molecular weights of hydrophobic blocks but with the same ionic block length. These block copolymers were successfully prepared via consecutive reversible addition-fragmentation chain transfer (RAFT) polymerization. The block copolymer with the shortest hydrophobic block length was surface-active; the solution showed surface tension reduction and foam formation. However, above the critical block ratio, the surface tension of the solution did not decrease with increasing polymer concentration, and there was no foam formation, indicating lack of surface activity. After addition of 0.1 M NaCl, stable foam formation and slight reduction of surface tension were observed, which is reminiscent of the electrostatic nature of the non-surface activity. Fluorescence and dynamic and static light scattering measurements showed that the copolymer with the shortest hydrophobic block did not form micelles, while the block copolymers formed spherical micelles having radii of 25-30 nm. These observations indicate that micelle formation is also important for non-surface activity. Upon addition of NaCl, cmc did not decrease but rather increased as observed for non-surface-active block copolymers previously studied. The micelles formed were very stable, and their size decreased by only similar to 5 nm after addition of 0.1 M NaCl.