In the present work, the effects of copper, chromium and boron on the pyrolysis of wood and their distribution in the pyrolysis products were investigated. For this, the wood has been impregnated with chromium-copper-boron (CCB). In addition, to describe the effects of impregnation method, vacuum-pressure and dipping methods were also conducted. Thermogravimetric analysis (TGA) results show that an increase in the final residue and decrease in degradation temperature on both methods of treated wood compared to untreated wood. Then, slow pyrolysis experiments were carried out in a laboratory reactor. The mass balance of pyrolysis products is confirmed by TGA. Furthermore, the concentration of metals in the final residue is measured by inductively coupled plasma mass spectroscopy (ICP-MS). The results show that the final residue contains more than 45% of the initial amount of metal present in the treated wood. The phenomenon is more pronounced with vacuum-pressure treated wood. The heating values of pyrolysis products were analyzed. The heating value of charcoal obtained from treated and untreated wood is approximately same. But the heating value of tar from untreated wood is higher than the heating value of the tar from treated wood. (C) 2012 Elsevier B.V. All rights reserved.