A research was conducted to determine the flow and strength properties of cassava and yam starch glycerol composites for their application in the design of hopper or any other storage bin, with a consistent flow during the handling of the granular solids, in the food industry. The flow and strength properties of the bulk materials which include the consolidation, shear and unconfined yield stresses were determined at different bulk densities and glycerol concentrations in the range of 1.5-3.0 g/cm(3) and 15-25 ml glycerol per 100 g starch using a uniaxial compression test. The flowability of the bulk solids were classified using Jenike's flow specifications. The angles of internal and wall frictions of the bulk solids were determined from their yield loci. The hopper half angles were determined from the conical hopper design chart; and the friction factors, which account for the vibration in the arch thickness and the geometric configuration of the composites, were computed empirically. The results show that the compressive strength of the cassava and yam starch glycerol composites increased significantly with an increase in bulk density and a decrease in the glycerol concentration (p < 0.05). The cohesiveness of the composites increase with increasing glycerol concentration, up to 25 ml per 100 g starch, because of their increasing flow function (1 < ff < 2). The hopper half angle, friction factor and angles of internal and wall frictions of the cassava starch glycerol composite at 3.0 g/cm(3) were 18.0 degrees, 2.48, 43.0 degrees and 26.0 degrees, respectively. The higher angle of wall friction at 3 g/cm(3) implies that a steeper hopper wall is required for a consistent flow of the granular solids through a hopper. Crown Copyright (C) 2014 Published by Elsevier Ltd. All rights reserved.