Antimicrobial packaging materials were obtained by incorporation of lysozyme into cellulose acetate (CA) films. In order to achieve controlled release of lysozyme, the structure of the films was changed from highly asymmetric and porous to dense by modulating the composition of the initial casting solution The. highest release rate, soluble lysozyme activity and antimicrobial activity were obtained with the film prepared from 5% CA solution including 1.5% lysozyme. Increasing CA content in the casting solution decreased the porosity of the films, hence, reduced the release rate, maximum released lysozyme activities and the antimicrobial activities of the films. In contrast, immobilized lysozyme activities and the tensile strength of the films increased. The incorporation of lysozyme did not cause significant reductions in tensile strength and elongation at break values except in films prepared with 15% CA. This study showed the good potential of asymmetric CA films to achieve controlled release in antimicrobial packaging. (C) 2008 Elsevier Ltd. All rights reserved.