화학공학소재연구정보센터
International Journal of Multiphase Flow, Vol.37, No.4, 380-393, 2011
Experimental investigation of flow boiling characteristics in a cross-linked microchannel heat sink
This paper experimentally investigates flow boiling characteristics in a cross-linked microchannel heat sink at low mass fluxes and high heat fluxes. The heat sink consists of 45 straight microchannels each with a hydraulic diameter of 248 mu m and heated length of 16 mm. Three cross-links, of width 500 mu m, are introduced in the present microchannel heat sink to achieve better temperature uniformity and to avoid flow mal-distribution. Flow visualization, flow instability, two-phase pressure drop, and two-phase heat transfer measurements are conducted using the dielectric coolant FC-72 over a range of heat flux from 7.2 to 104.2 kW/m(2), mass flux from 99 to 290 kg/m(2) s, and exit quality from 0.01 to 0.71. Thermochromic liquid crystals are used in the present study as full-field surface temperature sensors to map the temperature distribution on the heat sink surface. Flow visualization studies indicate that the observed flow regime is primarily slug. Visual observations of flow patterns in the cross-links demonstrate that bubbles nucleate and grow rapidly on the surface of the cross-links and in the tangential direction at the microchannels' entrance due to the effect of circulations generated in those regions. The two-phase pressure drop strongly increases with the exit quality, at x(e,o) < 0.3, and the two-phase frictional pressure drop increases by a factor of 1.6-2 compared to the straight microchannel heat sink. The flow boiling heat transfer coefficient increases with increasing exit quality at a constant mass flux, which is caused by the dominance of the nucleation boiling mechanism in the cross-link region. (C) 2010 Elsevier Ltd. All rights reserved.