The objective of this study is to investigate the impact of syngas composition by varying the H-2/CO ratio (1:3, 1:1, and 3:1 by volume), the CO2 dilution (0%-40%), and methane addition (0%-40%) on laminar flame speed. Thus, laminar flame speeds of premixed syngas-air mixtures were measured for different equivalence ratios (0.8-2.2) and inlet temperatures (295-450 K) using the Bunsen-burner method. It was found that laminar flame speed increases with increasing H-2/CO ratio, while CO2 dilution or CH4 addition decreased it. The location of the maximum flame speed shifts to richer mixtures with decreasing H-2/CO ratio, while it shifts to leaner mixtures with the addition of CH4 due to its inherent slower flame speed. The location of the maximum flame speed is also shifted towards leaner mixtures with the addition of CO2 due to the preponderance of the reduction of the adiabatic flame temperature with increasing dilution. Comparison between experimental and numerical results shows a better agreement using a modified mechanism derived from GRI-Mech 3.0. A correlation, based on the experimental results, is proposed to calculate the laminar flame speed over a wide range of equivalence ratios, inlet temperatures, and fuel content. Copyright (C) 2013, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.