The present work describes the electrocatalytic oxidation of formaldehyde on a copper-polymer modified electrode. The deposition of polymeric film on the surface of carbon paste electrode (CPE) was carried out using consecutive cyclic voltammetry in an aqueous solution of 2-aminodiphenylamine (2ADPA). The transition metal of copper is incorporated into the polymer by electrodeposition of Cu(II) from CuCl2 acidic solution using potentio-static technique. Characterization of different modified electrodes was studied using SEM technique and electron probe microanalyzer (EPMA). Cyclic voltammetry experiment of copper-poly(2-aminodiphenylamine) modified carbon paste electrode (Cu/P(2ADPA)/MCPE) in alkaline solution exhibited a number of well-defined anodic and cathodic peaks that are attributed to the Cu/Cu(I), Cu/Cu(II), Cu(I)/Cu(II) and Cu(II)/Cu(III) redox couples. The electrocatalytic oxidation of formaldehyde at the surface of Cu/P(2ADPA)/MCPE was studied by cyclic voltammetry and chronoamperometry methods. This new modified electrode found to be highly active and stable for electrooxidation of the formaldehyde so that the electrocatalytic current density of 25.56 mA cm(-2) was obtained at the potential of 0.63 V. The effects of various parameters such as the copper loading, scan rate and formaldehyde concentration on the electrocatalytic oxidation of formaldehyde were also investigated. Finally, using a chronoamperometric method, the catalytic rate constant (k) for oxidation of formaldehyde was found to be 7.16 x 10(6) cm(3) mol(-1) s(-1). Copyright (C) 2012, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.