Novel proton-conducting polymer electrolyte membranes have been prepared from bacterial cellulose by incorporation of phosphoric acid (H3PO4/BC) and phytic acid (PA/BC). H3PO4 and PA were doped by immersing the BC membranes directly in the aqueous solution of H3PO4 and PA, respectively. Characterizations by FTIR, TG, TS and AC conductivity measurements were carried out on the membrane electrolytes consisting of different H3PO4 or PA doping level. The ionic conductivity showed a sensitive variation with the concentration of the acid in the doping solution through the changes in the contents of acid and water in the membranes. Maximum conductivities up to 0.08 S cm(-1) at 20 degrees C and 0.11 S cm(-1) at 80 degrees C were obtained for BC membranes doped from H3PO4 concentration of 6.0 mol L-1 and, 0.05 S cm(-1) at 20 degrees C and 0.09 S cm(-1) at 60 degrees C were obtained for BC membranes doped from PA concentration of 1.6 mol L-1. These types of proton-conducting membranes share not only the good mechanical properties but also the thermal stability. The temperature dependences of the conductivity follows the Arrhenius relationship at a temperature range from 20 to 80 degrees C and, the apparent activation energies (E-a) for proton conduction were found to be 4.02 kJ mol(-1) for H3PO4/BC membrane and 11.29 kJ mol(-1) for PA/BC membrane, respectively. In particular, the membrane electrode assembly fabricated with H3PO4/BC and PA/BC membranes reached the initial power densities of 17.9 mW cm(-2) and 23.0 mW cm(-2), which are much higher than those reported in literature in a real H-2/O-2 fuel cell at 25 degrees C. Copyright (C) 2012, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.