This study deals with an investigation of the direct methanol oxidation in Solid Oxide Fuel Cells (SOFCs). A new catalyst formulation characterized by mixed electronic - ionic conductivity was developed for the anodic process. A composite Ni-modified La(0.6)Sr(0.4)Fe(0.8)-Co(0.2)O(3)-Ce(0.9)Gd(0.1)O(2) electrocatalyst was prepared by incipient wetness and subsequent ball milling. The obtained composite material was calcined at 1100 degrees C for 2 h in static air. After thermal activation, Ni was mainly present as highly dispersed La(2)NiO(4) particles on a La-depleted Sr(Fe(0.5)Co(0.5))O(2.88) perovskite. The subsequent thermal reduction at 800 degrees C in hydrogen caused the occurrence of highly dispersed metallic Ni on the electrocatalyst surface. The surface area of the composite material was determined by BET measurement. The reduced catalyst was used as anode in intermediate temperature Solid Oxide Fuel Cells (IT-SOFCs) directly fed with methanol. Ex-situ catalytic studies for the composite anode material under steam reforming, partial oxidation and autothermal reforming of methanol were carried out at 800 degrees C. A comparison of SOFC performance at 800 degrees C in the presence of syngas or methanol as fuels was carried out. The performance achieved for the direct utilization of methanol (350 mW cm(-2)) appears promising for SOFC application in remote and micro-distributed energy generation as well as for portable power sources. Copyright (C) 2011, Hydrogen Energy Publications, LLC. Published by Elsevier Ltd. All rights reserved.