In the present work, hydrotalcite-like compound precursor for preparing mixed oxide catalyst was successfully synthesized by a novel method, which was a combination of the reverse microemulsion and coprecipitation methods. it was observed that the precursor obtained from the above method possessed superior characteristics for preparing mixed oxide catalyst used in ethanol steam reforming (ESR). Furthermore, for comparison, catalysts prepared from conventional coprecipitation and impregnation methods had been characterized together with the catalyst prepared from the new method. Besides ICP, BET, X-ray diffraction (XRD), temperature-programmed reduction (TPR), H-2-TPD, TG, and TEM analytic techniques, catalytic performance for ESR was also investigated. The results of XRD and TPR indicated that a solid solution phase existed in the catalysts obtained from reverse microemulsion and coprecipitation methods, while spinel phase together with solid solution were observed in the catalyst obtained from the impregnation method. The high BET surface area of the catalyst obtained from the reverse microemulsion method enhanced the dispersion and the surface area of nickel, which improved the catalyst performance, From TEM images, the aggregated Ni could be found in the catalyst obtained from the impregnation method, while the hydrotalcite-like compound precursors prepared from reverse microemulsion and coprecipitation methods produced homogeneously distributed active Ni metal species. The catalyst obtained from reverse microemulsion exhibited the best activity, stability, and least carbon deposition because of the formation of hydrotalcite-like compound precursor, uniforrn dispersion of active Ni metal species, and much more surface area supporting the active Ni metal sites. (C) 2008 International Association for Hydrogen Energy. Published by Elsevier Ltd. All rights reserved.