For applications requiring 5-20 mW electrical power for 10-20 years, tritium-based radioisotope thermoelectric generators may be an alternative to Pu-238 based devices. Tritium can be stored compactly on a titanium bed. However, one of the main challenges then becomes loading the heat source at temperatures compatible with existing bismuth telluride thermoelectric module technology (<300 degrees C). We find that a 180 nm palladium coating enables titanium to be loaded with hydrogen isotopes without the typical 400-500 degrees C vacuum activation step. Further, we observe that the hydriding kinetics of Pd coated and vacuum activated Ti are similar; both of which can be described by the Mintz-Bloch adherent film model, where the rate of hydrogen absorption is controlled by diffusion through an adherent metal-hydride layer. Finally, we design a prototype heat source vessel and demonstrate that it can be loaded completely, at temperatures below 300 degrees C, in less than 10 h. (C) 2012 Elsevier Ltd. All rights reserved.