Coincident three-component solids velocity measurements are performed in a 8.7-m-high cylindrical riser (internal diameter 0.10 m) of a pilot-scale cold-flow Circulating Fluidized Bed set-up, using two Laser Doppler Anemometry (LDA) probes. Experiments are performed with superficial gas velocities of 3.5 and 5.3 m/s at riser heights from 0.9 to 5.5 m and with an average solids volume fraction of 0.0002. At the lower riser heights, the solids flow is observed to be highly disturbed clue to the asymmetrical position of both the air and solids inlet. A fully developed parabolic axial solids velocity field is observed about 2 m above the solids inlet line. The measured radial and azimuthal particle velocity components are significantly smaller than the axial one. The particle velocity fluctuations in the axial flow direction are larger than in the radial and azimuthal directions, showing that the solids flow is anisotropic. However, both the radial and azimuthal velocity fluctuations are higher than the corresponding mean velocities, as observed when studying the turbulence intensity in the three directions. All fluctuating velocities are decreasing significantly with increasing riser height, i.e. as the flow becomes more developed. No average down-flow of solids is recorded, not even close to the wall, due to the highly diluted flow. The total particle shear stress profiles designate a mean transport of fluctuating momentum along the riser radius due to velocity fluctuations. The particle fluctuation energy calculated based on experimental data indicates that the solids flow is dominated by wall-particle rather than intra-particle collisions. (C) 2013 Elsevier Ltd. All rights reserved.