A novel synthesized polyaluminum chloride-poly(3-acrylamido-isopropanol chloride) (PACl-PAMIPCl) an inorganic-organic hybrid polymer was prepared with poly(3-acrylamido-isopropanol chloride) (PAM-IPCl) and polyaluminum chloride (PACl) through physical blending. Ammonium persulfate ((NH4)(2)S2O8) and sodium bisulfite (NaHSO3) were used to initiate the redox polymerization of PAMIPCl at 50 degrees C by varying the molar ratio of epichlorohydrin (EPI) to acrylamide (AM). PAMIPCl of high viscosity was prepared when EPI to AM molar ratio attains 6%:94%. PACl-PAMIPCl hybrid polymers were characterized by Fourier Transform Infrared Spectroscopy (FT-IR), Transmission Electron Microscope (TEM), conductivity and viscosity. Effects of solution molecular weight/intrinsic-viscosity, dosage and pH of PACl-PAMIPCl hybrid polymers have been studied. One-way ANOVA shows that pH has a significant effect (p < 0.05) in flocculating both Reactive Cibacron Blue F3GA (RCB) and Disperse Terasil Yellow W-4G (DTY) dyes. The flocculation performance was evaluated with simulated dyes among PACl-PAMIPCl 2, PAMIPCl.c and PACl. PACl-PAMIPCl 2 with higher viscosity shows the best flocculation performance in treating both simulated dyes. It shows reduction of 92% for chemical oxygen demand (COD) and 95% for color at pH 7.5 using 50 mg/L of dosage for RCB dye. It gives reduction of 93% for COD and 96% for color at pH 3 using 20 mg/L of dosage for DTY dye. (C) 2014 Elsevier B.V. All rights reserved.