- Previous Article
- Next Article
- Table of Contents
International Journal of Coal Geology, Vol.104, 1-8, 2012
Influence of different boiling points of pore water around an igneous sill on the thermal evolution of the contact aureole
A low-permeability magmatic sill is capable of acting as cap rock to isolate the connection of pore fluids between overlying and underlying host rocks and consequently elevates the fluid pressure of the underlying host rocks towards the lithostatic pressure. For shallow, buried igneous sills, this will enhance the boiling point (T-boil) of and even cause the supercritical state of the pore water in the underlying host rocks during cooling of magma. By using an isolated diabase sill in Huimin Sag, Bohai Bay Basin, China as an example, this study presents an investigation on the effect of the different T-boil, (300 degrees C vs. 350 degrees C) or states (volatilization vs. the supercritical state) of pore water around the sill on the thermal evolution of the adjacent host rocks based on heat transfer models. Our results indicate: 1) Ignoring the difference in Tboil between the underlying and overlying host rocks can cause the maximum deviation of similar to 20 degrees C in the predicted peak temperature (T-peak) and of similar to 0.4% in the predicted vitrinite reflectance (VRr) if the T-boil below the sill is higher than that above the sill under real geological conditions: 2) Assuming the supercritical pressure for the pore water below the sill leads to the maximum deviation of more than 1.1% in VRr, and of at least 50 degrees C in T-peak, relative to the situation assuming the same T-boil for all the host rocks; 3) The observation and analysis based on drill cores show that the T-peak profile of the host rocks should be asymmetric to the horizontal central line of the sill. The thickness of the inner thermal alteration zone (hornfels zone) is somewhat larger below the sill than above the sill, whereas the outer thermal alteration zone (carbargilite zone) below the sill is obviously thicker than that above the sill. Only the predicted T-peak profile by the model assuming the supercritical pressure for the pore water below the sill can match with such observation. This demonstrates that the assumption of the different states of pore water represents natural conditions. (C) 2012 Elsevier B.V. All rights reserved.
Keywords:Igneous sill;Heat transfer model;Vitrinite reflectance;Supercritical state;Volatilization;Contact metamorphism