Glycidoxypropyltrimethoxysilane (GPS) and -aminopropyltrimethoxysilane (APS) were used to modify the surface chemistry of polyamide fibre. The surface chemistry was characterised using X-ray photoelectron spectroscopy. The silanol functional group was designed to be introduced on the surface of polyamide fibre to increase its chemical activity by N-alkylation of GPS and hydrolysis of APS, and to improve the poor interfacial adhesion between a polyamide 66 fibre and an aqueous polyurethane polymer adhesive. The microbond test was used to measure the interfacial shear strength between the waterborne PU adhesive and the polyamide fibre. It has been found that APS hydrolysis and GPS-alkylated fibre surface can be used to improve the interfacial adhesion of polyamide fibre to PU. The IFSS can be improved by N-alkylation of GPS from 5.0 to 8.4MPa. After water immersion at 50 degrees C for 48h, then drying, the IFSS increased to 8.8MPa due to the plasticisation of PU in water. Better interfacial adhesion was also observed by the hydrolysis of APS, but not significantly improved by this method due to the relatively weak hydrogen bond at the interface between APS and polyamide fibre.