Breath figure formation was carried out directly on the surface of poly(methylmethacrylate) using a mixture of a good solvent, tetrahydrofuran, and a nonsolvent, water. Direct breath figure formation was coined for this method and a mechanism was proposed to describe the figure formation by the method based on hypothesizes available for the normal breath figure formation. The proposed mechanism is such that the sonication effect, immersion time, and water content on characteristics of the obtained figures can be explained. The figured surface was then made superhydrophobic with a water contact angle of 175 degrees using in situ growing of perfluoro modified silica nanoparticles inside the figure cell by one-pot method. The spherical modified silica nanoparticles were detected being trapped by figure features providing a mechanical entrapment of the low-surface energy nanoparticles. (c) 2013 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys, 2013