Turbulent drag reduction (DR) behavior of mixed nonionic polymer and anionic surfactant solutions in water was studied in a pipeline set up to explore the synergic effects of mixed additives on DR. The concentration of polymer polyethylene oxide (PEO) was varied from 0 to 2000ppm and the concentration of surfactant sodium dodecyl sulfate (SDS) was varied from 0 to 5000ppm. The critical aggregation concentration (CAC), where the interaction between the polymer and the surfactant begins, and the polymer saturation point (PSP), where the polymer molecules become saturated with the surfactant, were determined using electrical conductivity and surface tension measurements. As the polymer concentration was increased the CAC decreased but the PSP increased. The relative viscosity showed a remarkable increase upon the addition of surfactant to the polymer solution due to extension of polymer chains caused by the formation of micelles on the backbone of the polymer molecules. The data exhibited a considerable increase in DR in the case of mixed polymer/surfactant systems. The percent reduction in friction factor was as high as 79 when 3000ppm or more surfactant was added to the 500ppm polymer solution. Furthermore, the drag reduction behavior of the polymer solution changed from so-called Type A to Type B. In Type A drag reduction, a transition from laminar to turbulent regime is observed with a clear-cut onset point. In Type B drag reduction, no transition or onset point is observed; the data fall on a gradual extension of the laminar line.