High-speed melt spinning of poly(ethylene terephthalate) was performed using a spinning nozzle with an inserted metallic wire of various lengths (0, 8, 30, and 45 mm). The molecular orientation of as-spun fibers increased with the increase in the wire length at all the take-up velocities examined. Along with the enhanced molecular orientation, the longer wire length led to the starting of orientation-induced crystallization at lower take-up velocities. The structure of crystallized fibers obtained at low speeds can be characterized by high crystallinity and relatively low molecular orientation. From the on-line measurement of the diameter and temperature profiles of the spin line with the 30-mm metallic wire, it was revealed that the spin-line had a maximum diameter of about 6 mm at the wire end. The spin-line temperature at this position was about 190 degrees C. The solidification of the spin-line occurred at positions much closer to the spinneret in comparison with ordinary high-speed spinning. These results show that high-speed spinning with a wire inserted in the nozzle corresponds to a spinning process operated at extremely low extrusion temperature using a nozzle with an extremely large diameter. From the starting of orientation-induced crystallization at lower levels of birefringence in comparison with ordinary high-speed spinning, the alteration of the inherent fiber structure that cannot be represented by birefringence was also suggested.