The melt grafting of glycidyl methacrylate (GMA) onto powdered isotactic polypropylene (PP) in a Haake Rheocord RC90 mixer was studied. Grafting degrees were determined by nonaqueous back titration of trichloroacetic acid with sodium hydroxide. The extent of degradation and crosslinking of PP during grafting was indicated by the melt-flow rates (MFR) of the grafted samples. The influences of GMA concentration, initiator type and concentration on grafting degree, reaction efficiency, and degradation were evaluated. A novel method was developed to obtain a high grafting degree with little degradation of PP using acrylamide (AM) as the initiating agent. The grafting process occurred before or during the melting of PP (i.e., solid-state grafting), at which temperature crosslinking is preferred over chain scission. Primary free radicals generated from the rapid decomposition of AM have a higher tendency to attack GMA molecules than PP chains. At the same estimated amount of primary radicals, both grafting degree and grafting efficiency increase with decreasing decomposition temperature of the initiator (for the same decomposition half-life) in the order of AM > benzoyl peroxide (BPO) > 2,5-di(t-butylperoxy)-2,5-dimethyl-3-hexyne (LPO). Functionalized PP with the desired grafting degree and little degradation of PP could be obtained by the use of mixed initiators.