Sulfurization of copper indium gallium diselenide (CIGS) thin films solar cell absorber has been used to enhance the open-circuit voltage of the device by increasing the band gap of the absorber near the interface. Sulfurization of a homogeneous co-evaporated Cu(InGa)Se, thin film was studied in hydrogen sulfide and in a Mixture of hydrogen sulfide and hydrogen selenide gases with the inclusion of oxygen. The structural and compositional properties of the absorber layer were investigated by XRD, EDS and AES. Sulfurization in hydrogen sulfide gas forms a fully converted sulfide layer at the top of the absorber layer, which in turn forms a barrier for the current collection. Sulfurization in a mixture of hydrogen sulfide and hydrogen selenide gases forms a wide hand gap Cu(InGa)(SeS)(2) layer at the Surface, but at the same time there is Ga diffusion away from the surface with the inclusion of sulfur at the surface. (c) 2005 Elsevier B.V. All rights reserved.