During the last 5 years the PV industry continues to experience a strong economic growth between 15 % and 30% per year. Multi-crystalline silicon became the preferred material for PV production with a share of more than 50% of the shipped PV modules world-wide. For the first time, the available quantity of the classical silicon feedstock sources for the PV industry-electronic grade silicon rejects from the silicon and microelectronics industry-is close to be not sufficient to satisfy the requirements of the PV industry, From this situation arises the need to develop short- and long-term solutions to guarantee a sustainable supply of the PV industry with suitable silicon feedstock at acceptable costs. This paper presents a possible route for short- and long-term solutions to provide solar grade (SoG) silicon feedstock for the PV industry. On a short-term basis a twofold solution is proposed: (i) reduction of silicon consumption by reducing the wafer thickness and the introduction of recycling scenarios for silicon waste produced by the PV industry, (ii) introduction of very low-resistivity silicon (0.1 Omega cm). On long term, a route towards the establishment of a SoG silicon production based on widely available metallurgical grade silicon is proposed. This route includes the development of suitable purification techniques. First results that allowed to lower the impurity tolerances for SoG silicon are presented, The introduction of silicon feedstock with higher impurity concentrations which show a tendency to interact with crystal defects and lead to a degradation of the material performance also requires passivation concepts to achieve highly performing solar cells. (C) 2002 Elsevier Science B.V, All rights reserved.