QuickRisk is a quantitative risk assessment tool developed at the Health and Safety Laboratory for use in assessing societal risk around onshore major hazard installations to inform land-use planning decisions. It uses release scenario information, parameterised consequence models, weather data, and population data from the National Population Database (NPD). This paper describes enhancements to the NPD methodology to include workplace populations. It describes the novel numerical, graphical and geographical representations of societal risk produced by QuickRisk. F-N data are analysed in terms of scenario FN curves and Delta PLL vs. N curves, where PLL is potential loss of life. The Delta PLL curves could be useful for comparison of FN curves against FN criterion lines or other FN data on a PLL basis. Geographical representations generated from PLL density maps show: the distribution of PLL dominating release scenarios or the percentage of risk contributed by the PLL-dominant release scenario, the maximum number of fatalities associated with the worst-case event, and the associated release scenario. Geographical representations are also generated of the maximum population that would meet a PLL density criterion, and the relative population change that would match a given PLL density criterion. These novel representations of societal risk could be useful for more effective communication between stakeholders on the risk levels in the vicinity of major hazard installations. Crown Copyright (C) 2011 Published by Elsevier B.V. on behalf of The Institution of Chemical Engineers. All rights reserved.