A multicompartment model is proposed for a semibatch melt polycondensation of poly(ethylene terephthalate) in a rotating disk polymerization reactor and compared with laboratory experimental data. The reactor is a horizontal cylindrical vessel with a horizontal shaft on which multiple disks are mounted. The reactor is assumed to comprise N equal sized compartments and each compartment consists of a film phase on the rotating disk and a bulk phase in which disks are partially immersed. The effects of disk rotating speed, number of disks, reaction temperature, and pressure were investigated. It was observed that ethylene glycol is predominantly removed from thin polymer layers on the rotating disks and the enhanced interfacial area exerted by ethylene glycol bubbles accounts for about 30-50% of the total available interfacial mass transfer area. Although the rate of polymerization increases as more disks are used, the maximum number of disks in a reactor must be determined properly in order to prevent the formation of thick polymer films that result in a reduced specific interfacial area and reduced polymerization efficiency. At a fixed reaction pressure, the equilibrium conversion is reached but the rate of reaction can be further increased by increasing the reaction temperature. The results of the proposed multicompartment model are also compared with those predicted by a simple one-parameter model.