Materials Research Bulletin, Vol.43, No.12, 3389-3396, 2008
Ion exchange and electrochemical evaluation of the microporous phosphate Li(9)Fe(7)(PO(4))(10)
A new lithium iron(III) phosphate, Li(9)Fe(7)(PO(4))(10), has been synthesized and is currently under electrochemical evaluation as an anode material for rechargeable lithium-ion battery applications. The sample was prepared via the ion exchange reaction of Cs(5)K(4)Fe(7)(PO(4))(10) 1 in the 1 M LiNO(3) solution under hydrothermal conditions at 200 degrees C. The fully Li(+)-exchanged sample Li(9)Fe(7)(PO(4))(10) 2 cannot yet be synthesized by conventional high-temperature, solid-state methods. The parent compound 1 is a member of the Cs(9-x)K(x)Fe(7)(PO(4))(10) series that was previously isolated from a high-temperature (750 degrees C) reaction employing the eutectic CsCl/KCl molten salt. The polycrystalline solid 1 was first prepared in a stoichiometric reaction via conventional solid-state method then followed by ion exchange giving rise to 2. Both compounds adopt three-dimensional structures that consist of orthogonally interconnected channels where electropositive ions reside. It has been demonstrated that the Cs(9-x)K(x)Fe(7)(PO(4))(10) series possesses versatile ion exchange capabilities with all the monovalent alkali metal and silver cations due to its facile pathways for ion transport. I and 2 Were Subject to electrochemical analysis and preliminary results suggest that the latter can be considered as an anode material. Electrochemical results indicate that Li(9)Fe(7)(PO(4))(10) is reduced below 1 V (vs. Li) to most likely form a Fe(0)/Li(3)PO(4) composite material, which can Subsequently be cycled reversibly at relatively low potential. An initial capacity of 250 mAh/g was measured, which is equivalent to the insertion of thirteen Li atoms per Li(9+x)Fe(7)(PO(4))(10) (x= 13) during the charge/discharge process (Fe(2+) + 2e -> Fe(0)). Furthermore, 2 shows a lower reduction potential (0.9 V), by approximately 200 mV, and much better electrochemical reversibility than iron(III) phosphate, FePO(4), highlighting the value of improving the ionic conductivity of the sample. (c) 2008 Elsevier Ltd. All rights reserved.
Keywords:Inorganic compounds;Microporous Materials;Intercalation reactions;Electrochemical measurements;Electrochemical properties