Steam stimulation is one of the viable methods to extract heavy oil from oil sand reservoirs in Alberta. In this thermal process, steam is injected into the oil sand reservoir. The oil sand formation expands due to an increase in pore pressure and thermal heating. This expansion results in an upward movement of the overburden, and thus, heaving of the free ground surface. This paper proposes an analytical method to estimate the surface heave induced by steam injection. The method was used to investigate the surface heave profiles under horizontal well injection. It was found that the surface heave profile is governed by the mass and heat transfer and distribution within the oil sand reservoir. The effect of the increase in pore pressure (or decrease in net overburden stress) on the surface heave is also compared to that due to the thermal expansion of the oil sand. The paper also discusses the limitations on the use of surface heave monuments and tiltmeters in monitoring the thermal recovery process.