Journal of Canadian Petroleum Technology, Vol.44, No.7, 27-33, 2005
Best method to balance torque loadings on a pumping unit gearbox
In general there are three methods available to the operator to determine the net torque loading on a. pumping unit's gearbox. Two dynamic methods determine the instantaneous torque throughout the pumping cycle. Method 1 combines the measured surface dynamometer card and calculated torque factors with measured or calculated counterbalance moments from the crank and weights. Method 2 uses measured motor power with; motor and drive efficiencies and the pumping unit speed to calculate, gearbox-torque. The third-method, combines the counterbalance effect (CBE) with the measured dynamometer loads and the torque factors to compute the net torque on the gearbox. The CBE test is a direct method of determining net gearbox torque at a specific crank position to estimate the maximum counterbalance moment. This static test is where the :cranks and, counterweights are held level until no upward or downward movement is noticed when the break is released. Field case: studies applying all three methods to determining gearbox torque are presented in this paper. The pros and cons of using each method are discussed.