Thermal stresses are determined in a single lap joint with identical adherends, which are due solely to temperature changes. The simple bending model used here includes bending and extension of the adherends and extensional and shear strains in the adhesive. The analytical solution shows 'sinusoidal' deformation consistent with warpage (bending) of the adherends due to thermal mismatch. While a modified shear lag model (MSLM) with no adherend bending leads to peak bondline shear stresses which occur only at the ends of the overlap, the bending model shows that such stresses occur not only near the ends, but also at interior points of the overlap region. Results for aluminum adherends and an epoxy adhesive show how the peel, warpage and interfacial shear stresses are distributed over the overlap region.