This paper deals with the stress analysis and strength evaluation of bonded shrink fitted joints subjected to torsion. The stress distributions in the adhesive layer of bonded shrink fitted joints are analyzed by the axisymmetric theory of elasticity when an external torsion is applied to the upper end of the shaft. The effects of the outer diameter and the stiffness of rings on the interface stress distributions are clarified by numerical calculations. Using the interface stress distributions, the joint strength is predicted. In addition, the joint strength was measured experimentally. It is seen that rupture of the adhesive layer is initiated from the upper edge of the interface when torsion is applied to the upper end of the shaft. The numerical results are in fairly good agreement with the experimental results. It was found that the joint strength of bonded shrink fitted joints is greater than that of shrink fitted joints.