The stress wave propagation and the stress distribution in adhesive butt joints of T-shaped similar adherends subjected to impact bending moments are calculated using a three-dimensional finite-element method (FEM). An impact bending moment is applied to a joint by dropping a weight. The FEM code employed is DYNA3D. The effects of the Young's modulus of adherends, the adhesive thickness, and the web length of T-shaped adherends on the stress wave propagation at the interfaces are examined. It is found that the highest stress occurs at the interfaces. In the case of T-shaped adherends, it is seen that the maximum principal stress at the interfaces increases as Young's modulus of the adherends increases. In the special case where the web length of T-shaped adherends equals the flange length, the maximum principal stress at the interfaces increases as Young's modulus of the adherends decreases. The maximum principal stress at the interfaces increases as the adherend thickness decreases. The characteristics of the T-shaped adhesive joints subjected to static bending moments are also examined by FEM and compared with those under impact bending moments. Furthermore, strain response of adhesive butt joints was measured using strain gauges. A fairly good agreement is observed between the numerical and the experimental results.