Polymer processing has been limited by the lack of direct flow and pressure control of the polymer melt at multiple points in space and time. Improved axial and radial valve designs are discussed that require negligible actuation force to control the flow of the pressurized melt. The forces resulting from pressure loads and shear stresses are first analyzed for an axial valve pin. Subsequently, a radial valve design is implemented and experimentally characterized using neat polycarbonate. A sigmoidal response surface is fit to the experimental data and found to very well model the observed pressure drop as a function of flow rate and valve pin position. The juncture loss at the valve port is then characterized by estimating and removing the pressure drops in the circular flow segments of the valve. Analysis indicated that the juncture loss is inversely proportional to the exposed area, or vesica piscis, formed between the circular flow channel in the valve body and the flow port on the moving valve pin. While applicable to many different polymer processing operations, the validated models are used to show the dynamic valve pin position as a function of the desired flow rate and desired cavity pressure in the hot runner of an injection mold. Finally, the impact of the designs on lower power, more compact mechanical and control system designs are discussed.